PRO 900Mhz INDUSTRIAL WIRELESS ACCELEROMETER - VIBRATION METER

SKU: ITS2-9-IN-AC-VM

PRO Vibration Meters use an accelerometer to measure g-force on 3 axis and then determine speed and frequency. They can be set to only capture when a vibration occurs and sleep when no vibrations are present, or they can be set to measure at a given assessment interval regardless of whether a vibration has occurred. If set to always measure, the sensitivity can be further adjusted to filter out noise. The Vibration Meter will also report the duty cycle, or how long the sensor was measuring vibrations throughout the heartbeat.


Important:Tank gauges that are not R3D ready can be upgraded with an R3D gauge from one of these vendors:

  • Rochester Gauge
  • Squibb Taylor

 

Warning: If you do not have a dial that is R3D compatible, do NOT attempt to change the dial yourself. Please contact your propane supplier and ask them for a replacement dial that supports the R3D standard. The float gauge inside the tank does not need to be replaced, just the plastic dial that reports the propane level inside the tank. (Compare your dial to those in the following Images included in this section and verify which one is installed on your tank. If R3D ready, p

 

* Actual range may vary depending on environment.
** Battery life is determined by sensor reporting frequency and other variables.

 

 

  • PRO - Leading Enterprise Grade "Internet of Things" Solutions

    PRO sensors offer 3 to 4 times the range of standard sensor platforms, extending non-line-of-sight reach to an exceptional 1,000+ feet through walls (12-14 walls typical). Using Frequency-hopping Spread Spectrum (FHSS) also allows PRO sensors to have better interference immunity from other wireless devices.

    Superior power management provides PRO sensors with almost twice the battery life of Itokii’s standard wireless sensors.

  • Coin cell sensors typically last 3+ years.
  • AA and Industrial sensors typically last up to 10+ years.
  • PRO products employ  new Encrypt-RF™ Security (256-bit Diffie Hellman key exchange and AES-128 CBC encryption for all sensor data messages), so security is maintained at all communication points from sensor to gateway, gateway to software, then back again.

     

    Integrated on-board data storage allows PRO sensors to store data messages if communication to a wireless gateway is disrupted (power outage, Internet outage, or out of range). Messages that can’t be delivered will be time-stamped and stored in memory (up to the last 512 messages) until communication with the gateway is restored, at which point the messages will all be transmitted.

    Over-the-air updates allow PRO products to be updated remotely if new fixes or features become available.

    Itokii PRO Industrial Sensors come in an IP65, NEMA 4X, CE rated, sealed, and weatherproof enclosure. They are powered by a single, replaceable, Industrial grade 3.6 V battery (included).

    An optional solar powered version is also available. The solar powered version includes a Lithium Iron Phosphate rechargeable battery in conjunction with a solar power cell to keep the battery charged and at optimal capacity. If there is no light present at the solar cell, the battery alone could continue to power the sensor for up to 8-10 years.

     

  • YouTube
  • LinkedIn

Copyright Inicius LLC. All rights reserved. © 2020, Itokii.